Electricity Consumption

Electricity consumption is a large fraction of our overall energy use. Electricity is generated using both fossil fuels and renewable energy sources. In this assignment, you’ll review the basics of electricity, some energy sources, and examine electricity flow and efficiency. [40 points total]Conceptual and quantitative problems. You will only receive credit if you show all your work and write legibly.I. Electricity Basics1. ___________ is the capacity is to do work. ________________ is the rate at which work is done. [1 pt]2. A circuit includes a 9 V battery and a copper wire of a given length and diameter. You measure the current in the wire to be 1.5 Amperes.a. What is the resistance of the wire? Your answer should be in Ohms. [1.5 pts]b. With this battery and wire, how much power can be provided? Report your answer in Watts. [1 pt]c. What changes could you make to the wire to increase the power? [2 pts]d. If you half the resistance of the wire, what is the power output? [1.5 pts]e. If you double the voltage of the battery, what is the power output? [1.5 pts]3. You have been using a 75W traditional incandescent light bulb in your desk lamp. However, you have learned about LED light bulbs and decided to replace your inefficient light bulb with a 12W LED that provides the same amount of light.a. Assuming that you are using your lamp for 5 hours per day and the electricity rate is 15 cents per kilowatt-hour, what is your annual energy cost savings? [2 pt)b. The incandescent bulb cost about $0.75, and the LED bulb cost about $6.00. Based on the energy savings, does the LED bulb save you money in the long run? For more information, visit: http://energy.gov/energysaver/lighting-choices-save-you-money. [1 pt]II. Electricity Generation and Transmission4. Although our small electronics like cell phones and flashlights use direct current, the electricity coming into our homes is alternating current. What is the advantage of transporting electricity on the large scale using AC instead of DC? [1 pt]a. Voltage can be stepped up or down using a transformer with A/C.b. More materials can be used as conductors with A/C.c. Less electrical energy is lost to heat with A/C.d. Ohm’s Law restricts D/C, but not A/C.5. At the large scale, electricity cannot be effectively stored with current technology (though the technology is improving https://www.eia.gov/todayinenergy/detail.php?id=40072). In other words, the electricity generated and transmitted over the power lines needs to match the electricity that is being used. ISO New England is an organization that carefully predicts how much energy will be used in the New England power grid during every hour of every day. They then communicate with energy generating companies (nuclear, solar, gas-burning power plants, etc.) to supply the most economic electricity to the grid at a certain time. Visit the ISO New England website: http://www.iso-ne.com.a. What is the current actual demand (MW) and fuel mix (percentages)? [1 pt]b. Describe the daily pattern of system demand (i.e. what time of day is energy use high or low). [1 pt]c. At the top of the page, click on the “About Us” tab. Under “What We Do”, click on “Our Three Critical Roles,” click on “Grid Operation.” Scroll down and read the section “Forecasting New England’s Electricity Use.” What three factors largely determine the hourly demand for electricity? [1 pt]d. Read the section “Dispatching the Power System.” Why does ISO-NE take the pulse of the power grid every few seconds? [1 pt]e. Energy sources can be described as dispatchable (can provide electricity on demand, can be turned on or off relatively quickly) or non-dispatchable or intermittent (timing and/or amount of electricity generation cannot be controlled by operators). What are the challenges in using non-dispatchable sources (such as solar or wind) to provide all of the needed electricity for the region? [1.5 pts]f. At the top of the page, click on the “About Us” tab again. Under “Key Grid and Market Stats,” click on “Electricity Use.” Scroll down to the graphs showing projected annual energy use with and without EE (energy and efficiency improvements) and PV (photovoltaics) savings. Which has a greater impact on energy use and summer peak demand? EE or PV? [1 pt]g. Read the report from ISO New England on air emissions from electricity generation: https://www.iso-ne.com/about/key-stats/air-emissions. What are the top 6 factors that have contributed to a reduction in emissions from electricity generators? [2 pts]III. Energy Flow6. The Lawrence Livermore National Laboratory publishes flow charts for energy for multiple countries and states. Visit https://flowcharts.llnl.gov/commodities/energy.a. In 2019, the United States consumed __________ Quads of energy per year. Of this, _________ Quads is lost as rejected or waste energy. _________ Quads of the rejected energy comes from electricity generation. [1 pt]b. If the going rate for electricity is $0.15/kWh, what is the “cost” of the wasted energy from electricity? Report your answers in trillions of dollars. [1.5 pts]c. What is the fate of most of this “rejected energy?” Energy cannot be created or destroyed, so where does it go? [1 pt]7. The Lawrence Livermore National Laboratory published flow charts for both energy and carbon